Cat's PM-465 has simplified grade and slope control system that provides three operating menus. On-board electronics also regulate speed, steering and rotor drive, plus self-diagnostics. Milling ...
The BM 2200/65 milling machine has a maximum milling width of 58 inches. The 60,296-pound half-lane mill has a 630-horsepower engine that matches power with milling speed for efficient milling to ...
I bought a small nth-hand milling machine a few years ago, as a challenge to see if I could ‘CNC’ it. It is a Clarke CMD10, one of the many re-badged versions of X1 made by Sieg in China And after ...
MAIJA-FRÄSTECHNIK GmbH milling discs are formed in hard metal, not of HSS, so that cutting edges slowly round off while the amount of material removed slowly decreases. They can be resharpened up to ...
Today, milling machines are recognized as an integral part of the process for achieving quality pavement performance standards. Take a look at the journey these units have taken over the last 25 years ...
Modern milling machines look much the same as they did 30 years ago. However, they now must cut superalloys, titanium, and high-tensile steels to closer tolerances and at faster rates than before. To ...
The bulk of the milling machine market consists of half-lane machines weighing from 60,000 to 90,000 pounds and typically equipped with roughly 7-foot-wide cutting drums, which are powered by 600- to ...
Some results have been hidden because they may be inaccessible to you
Show inaccessible results
Feedback